A practical guide

Start with the actual project

Square the projection to the work surface first. Apply a scale correction only after both axes measure consistently.

Write down each measurement with its unit. Enter lengths in the displayed unit and keep counts separate from dimensions. If a product specification provides a value, use that value for the exact material or equipment involved.

Work through the calculation

1. Open the calculator and replace every example input that differs from your project.
2. Read the named results and their units. A negative remaining-space result describes a fit problem, not a usable dimension.
3. Save a baseline before changing assumptions. Adjust one measurement at a time to see what drives the result.
4. Use the comparison table and the exact values beneath the chart to check the effect of a change.
5. Export a worksheet or print the final result, then verify a sample before making an irreversible cut or purchase.

Project-specific checks

1. Measure a test square on the cutting surface, not the wall or projector housing.
2. Different horizontal and vertical corrections suggest tilt, keystone or aspect-ratio distortion. One uniform zoom cannot fix both.
3. Disable fit-to-page scaling and check several positions across the projection.
4. Recheck calibration after moving the table, projector or cutting mat.

Read rounding correctly

Whole-item counts may round upward to cover a requirement or downward to fit a space. The formula reference identifies ceil and floor operations. Displayed decimals are rounded for readability; calculations keep the underlying numeric precision.

When a number looks wrong

First check units and inside-versus-outside dimensions. Next check whether allowances were included twice. Finally compare the input assumptions with the project-specific checks above. The worked scenarios provide a reproducible starting point.